iDigi Logo
iDigi Connector for Wind River Linux: Getting Started Guide

Introduction

Welcome to the iDigi Connector for Wind River Linux Getting Started Guide! We will walk you through the steps of building and running your first iDigi Device Cloud enabled sample application using the Wind River Linux Workbench development environment.

In order to run this Getting Started Guide the host PC must be connected to the Internet and the M2M Gateway must have Internet access. A typical setup is shown in the diagram below.

image 1

Note: Before proceeding with the following steps, you must follow the instructions within the iDigi Connector for Wind River Linux Tour. This guide contains a sequence of steps that will help you become familiar with the iDigi Device Cloud.

To begin, proceed with Step 1: Activate your Evaluation License.

 

Digi Logo Copyright ©2012 Digi International Inc. All rights reserved.
90001324_A