P/N 93001188f

Release Notes for
Digi ClassicBoard Config Utilities

December 10, 1996

This software package includes the Configuration Utility for all Digi
Hawaii-series non-intelligent adapters.  It is used to (re)configure
an adapter for Plug And Play or legacy modes, as well as set various
I/O, IRQ and interrupt options.

This package makes use of the Hawaii Library, 40001447.  As the library
is updated, this product should update.


1. Enhancements

Added wait state selection.

2. Bug Fixes

Multiple Boards would cause 'unique' problems.  

3. Known Limitations

Certain Plug and Play BIOSes may behave incorrectly, and may incompletely
initialize Plug and Play adapters in the system.  Although steps have been
taken to try and eliminate this problem, the Utility may not recognize
a factory programmed (as a PnP device) Hawaii board.  If the Utility 
reports that no Hawaii class boards were found in the system, it is
necessary to run the "RST" program provided on the Utility disk.  This will
reset all PnP devices in the system and enable the Utility to detect the
Hawaii board installed.  It should not affect the operation of the system
at all.

Entering '..' for a path name at the root directory of a drive will hang the
system.

4. Manual Errata

None.