Table of Contents
- 1.1 RCM2200 Description
- 1.1.1 Physical & Electrical Specifications
- 1.2 Development Software
- 1.3 How to Use This Manual
- 1.3.1 Additional Product Information
- 1.3.2 Additional Reference Information
- 1.3.3 Using Online Documentation
- 2.1 Development Kit Contents
- 2.2 Prototyping Board
- 2.2.1 Prototyping Board Features
- 2.2.2 Prototyping Board Expansion
- 2.3 Development Hardware Connections
- 2.3.1 Attach Module to Prototyping Board
- 2.3.2 Connect Programming Cable
- 2.3.3 Connect Ethernet Network Cable
- 2.3.4 Connect Power
- 2.4 Where Do I Go From Here?
- 2.4.1 Technical Support
- 3.1 An Overview of Dynamic C
- 3.1.1 Hardware Requirements
- 3.2 Installing Dynamic C
- 3.2.1 Program & Documentation File Location
- 3.2.2 Installation Type
- 3.2.3 Select COM Port
- 3.2.4 Desktop Icons
- 3.3 Starting Dynamic C
- 3.3.1 Communication Error Messages
- 3.4 Sample Programs
- 4.1 TCP/IP Connections
- 4.2 Running TCP/IP Sample Programs
- 4.3 IP Addresses Explained
- 4.4 How IP Addresses are Used
- 4.5 Dynamically Assigned Internet Addresses
- 4.6 Placing Your Device on the Internet
- 4.7 How to Set IP Addresses in the Sample Programs
- 4.8 How to Set Up your Computer's IP Address for Direct Connect
- 4.9 Run the PINGME.C Demo
- 4.10 Running More Demo Programs With Direct Connect
- 4.11 Where Do I Go From Here?