Table of Contents
About This Manual
1. Introduction
- 1.1 Features
- 1.2 Development and Evaluation Tools
- 1.2.1 Development Kit
- 1.2.2 Documentation
- 1.2.3 Software
2. Getting Started Instructions
- 2.1 Software Installation
- 2.2 Getting Hooked Up
- 2.2.1 Prototyping Board
- 2.2.2 Jackrabbit Board
- 2.3 Starting Dynamic C
3. Subsystems
- 3.1 Switching Between Program Mode and Run Mode
- 3.1.1 Detailed Instructions: Changing from Program Mode to Run Mode
- 3.1.2 Detailed Instructions: Changing from Run Mode to Program Mode
- 3.2 Jackrabbit Inputs and Outputs
- 3.3 Digital Inputs/Outputs
- 3.3.1 Inputs
- 3.3.2 Outputs
- 3.4 A/D Converter
- 3.5 D/A Converters
- 3.5.1 DA1
- 3.5.2 DA0
- 3.6 High-Power Outputs
- 3.6.1 High-Power Sinking Outputs (HV0-HV2)
- 3.6.2 Configurable High-Power Output (HV3)
- 3.6.3 Connecting a Load to the High-Power Outputs
- 3.7 Serial Communication
- 3.7.1 RS-232
- 3.7.2 RS-485
- 3.7.3 Programming Port
- 3.8 Memory
- 3.8.1 SRAM
- 3.8.2 Flash EPROM
4. Software Reference
- 4.1 More About Dynamic C
- 4.1.1 Operating System Framework
- 4.2 I/O Drivers
- 4.2.1 Initialization
- 4.2.2 Digital Output
- 4.2.3 Analog Output
- 4.2.4 Analog Input
- 4.3 RS-232 Serial Communication Drivers
- 4.3.1 Open and Close Functions
- 4.3.2 Non-Cofunction Blocking Input Functions
- 4.3.3 Non-Cofunction Blocking Output Functions
- 4.3.4 Single-User Cofunction Input Functions
- 4.3.5 Single-User Cofunction Output Functions
- 4.3.6 Circular Buffer Functions
- 4.4 RS-485 Serial Communication Drivers
Appendix A. Specifications
Appendix B. Prototyping Board
- B.1 Mechanical Dimensions and Layout
- B.2 Using the Prototyping Board
- B.2.1 Demonstration Board
- B.2.2 Prototyping Board
Appendix C. Power Management
- C.1 Power Supplies
- C.2 Batteries and External Battery Connections
- C.2.1 Battery Backup Circuit
- C.2.2 Power to VRAM Switch
- C.2.3 Reset Generator
- C.3 Chip Select Circuit
Schematics
| Z-World http://www.zworld.com Voice: (530) 757-3737 FAX: (530) 753-5141 sales@zworld.com |