BL2600Q_unit_test_log.txt

Samples\
   OK: write_idblock_920_962.c
Samples\BL2600\
   OK: board_id.c
Samples\BL2600\ADC\
   OK: adc_cal_diff.c
   OK: adc_cal_ma.c
   OK: adc_cal_se_bipolar.c
      Updated to provide correct 10% / 90% calibration points for all supported
      single ended bipolar conversion modes.
   OK: adc_cal_se_unipolar.c
   OK: adc_rd_caldata.c
Samples\BL2600\DAC\
   OK: dac_cal_ma.c
   OK: dac_cal_volts.c
   OK: dac_rd_caldata.c
Samples\BL2600\IO\
   OK: digin_bank.c
   OK: digout_bank.c
   OK: pwm.c
Samples\BL2600\NandFlash\
   OK: nflash_erase.c
   OK: nflash_log.c
Samples\BL2600\Rabbitnet\
   OK: rn_led.c
Samples\BL2600\RS232\
   OK: parity.c
   OK: simple5wire.c
Samples\BL2600\RS485\
   OK: master.c
   OK: slave.c
Samples\BL2600\SF1000\
   OK: sflash_pattern_inspect.c
   OK: sflash_test.c
Samples\BL2600\TCPIP\
   OK: ssi.c
   OK: telnet.c
Samples\FileSystem\FAT\
   OK: fat_create.c
   OK: fat_hot_swap_sd.c
   OK: fat_nb_costate.c
   ?OK: fat_shell.c
     Will hang on "format 0" attempt if soldered-on nand flash is not already
     formatted and an already formatted SD card partition is mounted. This
     program will successfully format an unformatted soldered-on nand flash if
     no SD card is inserted or if the SD card is also initially unformatted.
   OK: fmt_device.c
      Note that this sample does not hang on formatting device 0, even under the
      same conditions as described for fat_shell.c's hang problem.
   OK: updpages.c
Samples\RCM3900\SD_Flash\
   OK: sdflash_inspect.c
      Note that this sample program can be used to clear pages 0-5 on the
      BL2600Q's SD card to effectively unformat partition(s) on the SD card.
Samples\tcpip\http\
   OK: refresh.c
   OK: static.c
Samples\UserBlock\
   OK: idblock_report.c
   OK: userblock_clear.c
   OK: userblock_info.c
   OK: userblock_sample.c

