XTend DigiMesh firmware revision history

DigiMesh firmware revision history for the XTend radio modems

XTend version numbers from 2000 on will have 4 significant digits. A version number is reported by ATVR with 4 numbers. All numbers are hexadecimal and can have a range from 0-0xF. A version is reported as "ABCD". Digits AB are the main release number and D is the revision number from the main release if D is 0, it is a major release. "B" is a variant designator. The following variants exist:

• "0" - Normal build
• "1" - Proprietary build
• "2" - Australian build

All releases will have an even number for C. All internal development will have an odd number for C. Field D is always present, even when D is 0.

Standard firmware releases start with 0x2000, and the DigiMesh firmware releases will start with 0x8000.

Table of contents

Version 8.0.2.0

November 11, 2007

• Added - Firmware support for XTIB-R in non-embedded (boxed) products.
  
• Eratta - None.
  

Version 8.0.1.4

May 11, 2007

• Added - MAC address is found in a new protected config.
  
• Fixed - There was a problem with not going back to configured baud rate after getting into command mode by pressing and holding the config switch.
  
• Eratta - None.
  

Version 8.0.1.3

February 2007

• Added - This firmware supports proprietary AODV Mesh features
  
• Added – This firmware now allows 64 bit addressing (MAC Address)
  
• Errata - There is a problem with not going back to configured baud rate after getting into command mode by pressing and holding the config switch.
  
• Eratta - Problem with not going back to configured baud rate after entering command mode