**************************************************************************

        Firmware Revision History - XBee-PRO 868 Radio Modems

**************************************************************************

**************************************************************************
*                       Version 1x31 Release Notes                       *
**************************************************************************
Release Date:  Jul 28, 2009


FEATURES
  Identical release to 1x27, with a version of 1x31.

BUG FIXES (since last release)
- None

ERRATA

-  If the receiving module is streaming data out the UART and a ‘+++’ is sent to 
the module it will not enter command mode until after there is a break in the 
data.

**************************************************************************
*                       Version 1x27 Release Notes                       *
**************************************************************************
Release Date:  May 21, 2009


FEATURES



BUG FIXES (since last release)

-  Fixed PWM RSSI Default - ATRP to 0x28.
-  Updated the .mxi file with ATIC, ATIR, ATLT, ATSB, ATD9, ATCK commands.
-  NI strings maintain case now.
-  ATM0, ATM1 are set when command mode exits or AC. ATM0, ATM1 can also be read.

ERRATA

-  If the receiving module is streaming data out the UART and a ‘+++’ is sent to 
the module it will not enter command mode until after there is a break in the 
data.

**************************************************************************
*                       Version 1026 Release Notes                       *
**************************************************************************
Release Date:  Febuary 13, 2009


FEATURES

BUG FIXES (since last release)

-  Fixed PWM RSSI mapping.
-  Fixed a problem where DIN/DOUT were not configured correctly for AIO/DIO adapters.

ERRATA

-  If the receiving module is streaming data out the UART and a ‘+++’ is sent to 
the module it will not enter command mode until after there is a break in the 
data.

**************************************************************************
*                       Version 1025 Release Notes                       *
**************************************************************************
Release Date:  January 12, 2009


FEATURES
-  ATIS, ATIC and ATIR commands added for AIO and DIO support
-  ATLT command added to set the power LED blink rate
-  ATCK diagnostic command was added to hash the current user configuration.

BUG FIXES (since last release)

-  Fixed a problem with unshipped production units where PL=2 was 
   outputting too much power.
-  Fixed a problem where ack's failed because the ack duty cycle was 
   incorrectly limited to 1% rather then 10%.

ERRATA

-  If the receiving module is streaming data out the UART and a ‘+++’ is sent to 
the module it will not enter command mode until after there is a break in the 
data.


**************************************************************************
*                       Version 1023 Release Notes                       *
**************************************************************************
Release Date:  November 7, 2008


FEATURES
-  None


BUG FIXES (since last release)
-  Fixed problem with loopback, where the endpoints were not getting swapped.



**************************************************************************
*                       Version 1022 Release Notes                       *
**************************************************************************
Release Date:  October 15, 2008


FEATURES
-  Initial Release


BUG FIXES (fixed since last release)
-  None