Release Notes PN 93000399_C
                     Digi One Realport, PortServer TS 2/4 EOS
                                  82000677_A4

                                   2001-12-04

INTRODUCTION

  This is an update release of firmware for the Digi One Realport and
  PortServer TS 2/4.  
 
SUPPORTED PRODUCTS

    Digi One Realport
    PortServer TS 2
    PortServer TS 4

ENHANCEMENTS

   All 4 ports of PortServer TS 4 may be set to different baud rates.

BUG FIXES


  7679) TS-4: changing baud rate of port 3 to 230400 causes data drop in port 4.

  7658) Binary data transfer is broken on port 2001


KNOWN LIMITATIONS

  7351) Reboot after sending Digi one many large, fragmented IGMP packets.

  7340) Printer issue, non-realport serial buffer drops data on close.
	
  7331) Telneting to unreachable IP's & connecting to them. 
	
  7325) set ports ra=* group=0 does not seem to work  

  7272) Cannot reverse telnet to port of dev type "host"

  7256) "set host name=abc" creates host entry with ip of 0.0.0.0

  7247) Who command causes no response from unit.

  7158) set host forgets hostname when 2 hostname point at same IP

  7150) Zoom modems are not properly auto detected on RealPort ports

  6993) Able to write to OID ipDefaultTTL with an out of range int value.

  6992) SNMP, cannot write to OID tcpConnState for int values of 12.

  6839) Printing out gets breaks.

  6715) set conf tbreak=any fails to operate

  6708) Turning the SNMP daemon on/off repeatedly causes reboot.

  6706) Cannot access charSess OID series, even when a user is logged in.

  6702) Cannot write to OID charPortOutFlowType for int values of 3.

  6701) Cannot write to OID charPortInFlowType for int values of 3

  6700) Cannot write to OID charPortReset for int values of 2.

  6697) Cannot write to RW OID ipRouteType for int values of 1 - 4.


ADDITIONAL INFORMATION 

	Running and Interpreting Digi One Realport PortServer TS 2/4 POST

	(Corrects the Table of LED Activity and indication.)
	
The Power-On/Status LED will flicker at a very fast rate while the Power-
On-Self-Tests are run.  This will take about 6 seconds from when the power 
is applied.  Once the tests are completed, a three-digit status-code is 
flashed on the LED, then the LED is turned on and the device is operational.

	
HISTORY

    2001-10-29
	Release B: 82000677_A3
    
    2001-09-20
	Release A: 82000677_A1

    2001-07-11
	Beta Release 1P