Release Notes for the AnywhereUSB/14
		82002081_F firmware (PN: 93000954_F)

			December 6, 2011

INTRODUCTION
	
	This is a production release of the AnywhereUSB/14 firmware (EOS).

SUPPORTED PRODUCTS
	
	AnywhereUSB/14

ENHANCEMENTS

	None

BUG-FIXES 
	Rev F
	- Added KeepAlive’s for each AnywhereUSB remote hub TCP/IP connection type: endpoint,
	  host controller, and system. This fixes a problem with firewalls that disconnect inactive
	  TCP/IP connections.
	- Change RSH and RLOGIN network services defaults to disabled.
	- Add work-around for non-compliant USB devices which improperly return full Device Descriptors
	  in response to partial "Get Device Descriptor" requests.
	- For security purposes, the AnywhereUSB Configuration Utility can no longer change the settings
	  of AnywhereUSB devices nor reboot them.  Rebooting and settings changes can only be done 
	  via the device's WebUI. The config utility is still used to connect/disconnect with AnywhereUSB 
	  devices/groups.
	- Eliminated “File Management” from WebUI.  It is never used and could be a potential security
	  issue.
	- Fixed Ethernet speed/duplex negotiation bug.
	
	Rev E
	- Fix Vantive #37074.  When doing a Device-to-Host Setup packet (Get operation),
	  if the TransferBufferLength was 0, we were sending an IN for the status stage, 
	  when we should have been sending an OUT. 
	
	Rev D
	- Fix ethernet lockup problem
	- Small ethernet performance improvements
	- Fix Vantive #36418 ("assertion: rlogin auth failed")
	- Fix Vantive #33549 (iDigi displayed version number incorrectly)
	- Fix assertion/reboot caused by host disconnection
	- Fix bug with Aladdin dongle enumeration
	
	Rev C
      	- Fixed several cases where the firmware would crash or reboot under heavy load.
      
 KNOWN ISSUES

	The current AnywhereUSB Configuration Utility will let users attempt to change settings of an
	AnywhereUSB remote hub without providing a warning that the AnywhereUSB remote hub will reject those
	changes.  The same applies to reboots from the configuration utility.  A forthcoming release of
	the AnywhereUSB host drivers will fix this.
	
	RSH and RLOGIN services do not work and are disabled by default in this release.  However,
	these services must be explicitly disabled if upgrading from an earlier release.  From the
	AnywhereUSB remote hub's web interface, click Network (under Configuration), then click 
	"Network Settings" and uncheck "Enable remote login (rlogin)" and uncheck "Enable remote shell(rsh)".
	Then click the "Apply" button.