Release Notes PN 93000573_C1 Digi Connect WAN VPN GSM Digi Connect WAN VPN EDGE10 Digi Connect WAN VPN S1X Digi Connect WAN VPN C1X Digi Connect WAN VPN V1X Digi Connect WAN VPN 1X 82001253_C1 EOS May 10, 2006 INTRODUCTION This is a production release of firmware for the Digi Connect VPN GSM, Digi Connect WAN VPN S1X, Digi Connect WAN VPN V1X, and Digi Connect VPN C1X. The Digi Connect WAN VPN family, part of the Digi Remote Site Management line of products, provide an alternative to traditional wired TCP/IP Wide Area Networks (WANs), utilizing global wireless Cellular, and IPSec VPN technology to create secure primary and backup network connectivity. They offer an easy, cost-effective, means of securely connecting virtually any remote location or device into the corporate IP network. SUPPORTED PRODUCTS Digi Connect WAN VPN GSM Digi Connect WAN VPN EDGE10 Digi Connect WAN VPN S1X Digi Connect WAN VPN V1X Digi Connect WAN VPN C1X Digi Connect WAN VPN 1X ENHANCEMENTS N/A BUG FIXES Fixed an issue, where, in certain circumstances, the device would not retain the correct default IP address assignment configuration (18544). KNOWN ISSUES On some IPSec VPNs, SA lifetime is not negotiated correctly. To work around this issue, configure the SA lifetime on the Digi Connect WAN VPN to be less than that configured on the VPN concentrator. IPSec VPN tunnels using AES encryption are restricted to 256-bit key lengths. DOCUMENTATION ERRATA None. HISTORY 82001253_C1 - May 10, 2006 - Fixed an issue, where, in certain circumstances, the device would not retain the correct default IP address assignment configuration (18544) 82001253_C - April 28, 2006 - SureLink (tm) link integrity monitor - DynDNS.org dynamic DNS support - Data-only SIM/plan support (GSM, EDGE10) - Additional wireless carriers support: Cellular One, Alltel, IUSACELL, Telstra - Generic GSM carrier updates - Mobile data throughput enhancements - Support for mobile IP mode selection (V1X, Verizon 1X) - Added support for 1X product - An issue which may have prevented negotiation of PAP over the mobile link was corrected - An issue was corrected where, under certain conditions, it was possible for the Digi Connect to be unaware of a dropped mobile link. 82001253_B - January 22, 2006 - Added capability to reset cellular module or device after a configurable number of failed originations. - Added features to support requirements for usage on the Verizon network - SIM PIN support for GSM carriers - Maximum number of NAT triggers is now configurable - Configurable delayed ACK, gratuitous ARP, RTO min/max, ARP TTL - Connections to Connectware Manager server can be compressed - Made RealPort protocol keepalives configurable with the "set realport" command, lowering aggregate protocol traffic. TCP keepalive should be used if RealPort protocol keepalives are disabled - Fixed an issue where the mobile IP address was not being transmitted correctly when used as a VPN identity. - Fixed an issue where, in rare cases, a VPN tunnel could stop passing data. - Fixed an issue where enabling or disabling a VPN tunnel could cause the device to re-boot if traffic was moving over the connection. - Enhanced capability of the device to re-connect to the mobile network if the connection is lost for any reason 82001253_A3 - November 1, 2005 - Fixed an issue with sporadic VPN GSM module initialization 82001253_A2 - September 9, 2005 - Added support for Digi Connect VPN C1X. - LCP keepalives 82001253_A - July 2, 2005 Initial release.